Browse our range of patio cover pergola by click here
There are several ways to attach Steelmates patio cover onto your house. The kit sets will come with a mounting bar the same length as the patio cover itself, it needs to be mounted onto a section of your house. The canopy has a return on the end to catch the groove on the mounting bar, then fastened with 2 bolts on each side of each purlin.
1. The easiest scenario is to attach to the wall directly.
The example below shows installation on a two-storey house
The example below is a patio cover installed on a one-storey house.
2. Attach patio cover directly onto fascia board.
3. If there is a gutter installed on the fascia board, and it is not enough space for the patio cover. You can mount a long piece of timber under the eaves, please make sure it is mounted onto the joists. Then the canopy can be mounted onto the side of the timber.
If you are working with limited space. The canopy can be shortened in two directions. It needs cutting of the aluminium extrusions and roof sheets.
4 Comment(s)
Hi,are the support post adjustable from side to side and back and forward.Our deck is 4.3 mtrs x 2 mtrs if so could you advise on the best size patio cover to purchase.
Cheers Albert.
Hi There I have just bought the 4.360mm x 3.050mm patio cover I am mounting it on a beam under the gutter it will be 2.3 meter from the deck to the facia mount as i need 2.2 to clear the doors opening out to the deck I cant go higher or lower to get the fall I cant afford to have the angle too much or the door will catch the underside of the canopy any tips would be grateful
hi there have u got anyone in the Wellington area that could install 1 of these units
Hi I'm looking at the 4.3m×2.5m as this will cover the deck area.i have 2 step downs in the deck which will drop post end 250mm wanted it higher can posts come in 1.1m from end of awning ?or do I need post extensions?
Leave a Comment